Aomway TX003 5.8G 64CH 0mw/25mw/100mw/200mw/400/600mw Smart Audio Pitmode FPV Transmitter VTX 

Features
Suppourt Smartaudio and Pitmode ,power and frequency can be adjusted by BetaFlight 

Can be controlled by remote control transmitter 

Anti-interference, support more than 8 drones flying at the same time

0mw/25mw/100mw/200mw/400mw/600mw 5 levels power switchable .Output is stable

Long transmission distance and stable signal,≥0.5km@25mW,≥0.8km@100mW.≥1km@200mW(original antenna) 

Stronger power filter can provide the high-quaility real-time image when the drone in full throttle. No snowscreen or any striped image etc..

64CH including 8 race frequencies in the E Band which are used without interference at the same time.

Frequency is locked fast, won't intefere the signal of others

Support NTSC and PAL

Wide voltage, low consumption
2 Working modes, CE mode and normal mode

Specification

Operation

Power and frequency can be adjusted by BF firmware. The Pitmode is in 0mW, used for setting in short distance

CE mode& Normal mode. (long press the button for 10s, it will switch between CE and normal mode once.)

In CE mode, the Smart Audio stops working. All CH LEDs flash in blue. Power output locked in 25mW, only 5 channels works : CH1:5725,CH2:5765,

CH3:5800,CH4:5843,CH5:5866MH , and channels only can be switched by button.

Button Control :  

Frequency Adjustment : Short prss to change from CH1- CH8

Band Selection : Long press 2s (Fr blue LED flash) into Band Select mode, then short press to change FR(A-H)

Power Switch : Long press 10s(LED shows as follow) into power mode, short press to switch the power  from 25mw/100mw/200mw/400/600mw

Notice : When use BF OSD to adjust the parameter, be noted that there are only 40CH available in FC, the other frequencies(Band F/G/H) must be adjusted by manual.

Package Inluded
1 x TX003 Transmitter
1 x RHCP 4-Leaf Antenna
1 x Molex Pico 1.25mm 6P to 4P AV Cable