The Mateksys F405-CTR flight controller has all the features of the original F405-OSD but now with the addition of a BMP280 barometer. The high-speed 168MHz 32bit F405 processor with BetaFlight firmware, OSD and BMP280 barometer gives this flight controller the power to easily control your drone.

It also has a blackbox to help you fine tune or to help determine what went wrong with any mishap. The OSD provides detailed information on battery voltage and other information. Also included is a PDB with an onboard 5V 2A continuous BEC system with 184A current sensor. This flight controller board is lightweight (only 10g) and because it has standard 30.5 x 30.5mm mounting holes in can easily fit into any drone.

Features:
• 168MHz STM32F405RGT6
• 6-axis MPU6000 accelerometer/gyro (SPI)
• BetaFlight OSD with AT7456E chip
• BMP280 (12C) barometer
• 4 x 30A 6 layer PDB
• 5V 2A continuous BEC (3A burst)
• 184A current sensor
• MicroSD BlackBox (SD/SDHC)
• VCP and 5 x UARTs
• 6 PWM/DSHOT outputs
• 12CI and DAC
• BF/NAV MatekF405 Target

Specs:
Input Voltage: 6~30V DC
MCU: 168MHz STM32F405
IMU: MPU6000 accelerometer/gyro (SPI) (6-axis)
Barometer: BMP280 (12C)
OSD: BetaFlight OSD w/ AT7456E chip
Blackbox: MicroSD card slot (SD/SDHC)
VCP: UART1, UART2, UART3, UART4, UART5
SBUS: Built in inverter for SBUS input (UART2-RX)
PPM/UART Shared: UART2-RX
SoftSerial Support: On S5 & S6
Camera Control: On S6 or DAC (optional)
VTX: Smartaudio and Tramp VTX protocol supported
Lights: WS2812 LED strip
Current Sensor: 184A
BEC: 5V 2A continuous (3A burst)
Voltage meter Scale: 1:10
LDO 3.3V: Max.300mA for Spektrum RX
Beeper: Yes
RSSI: Yes
Status LED's: 3 x LED's for FC STATUS (Blue, Red & 3.3V Red indicator)
PWM: 6 x PWM/DShot outputs without conflict
UART's: 5
Connections: 1 x group of G/S1/S2/S3/S4 pads for 4in1 ESC Signal/GND
                      4 x pairs of corner pads for ESC Signal/GND connections (DSHOT compatible)
                      1 x pair 12CI pads
Button: 1 x side-press button for BOOT(DFU) mode
Dimensions: 36x46mm PCB with 30.5mm mounting holes
Weight: 10g

Includes:
1 x Mateksys FC F405-CTR
1 x Rubycon ZLH 35V/470uF (Low ESR)
6 x Silicone M4 to M3 grommets
1 x FR4 PCB plate 36 x 36 x 1mm

Requires:
1 x Micro SD card (Up to 4GB)