PM02D Power Module

PM02D provides regulated power supply for your Pixhawk® 5X from the battery,  as well as current consumption and battery voltage measurements, all through a 6pin cable. The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 6S. The Power Module comes completely assembled with XT60 connectors, wrapped in shrink tubing for physical damage protection.
This Power Module is designed to power Pixhawk® 5X and its accessories (GPS, radio, receiver). It is not designed to power servos, please use your aircraft's ESC/BEC for that. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.

Note: PM02D uses I2C digital signal data output and not compatible with Pixhawk4, Pixhawk4 Mini, pix32 v5, or Durandal flight controllers

Spec：

• Max input voltage: 36V 
• Rated current: 60A
• Max current: 120A (<60S)
  Max current sensing: 164A
• Supports up to 6S battery
• Voltage and current monitor with I2C compatible interface 
• Switching regulator outputs 5.2V and 3A max 
• Weight: 20g

Current Rating:

The PM02D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly. The specifications and models are as follows:

PIN MAP:

Package Includes：